PUL-Mediated Plant Cell Wall Polysaccharide Utilization in the Gut Bacteroidetes

Plant cell wall polysaccharides (PCWP) are abundantly present in the food of humans and feed of livestock. Mammalians by themselves cannot degrade PCWP but rather depend on microbes resident in the gut intestine for deconstruction. The dominant Bacteroidetes in the gut microbial community are such bacteria with PCWP-degrading ability. The polysaccharide utilization systems (PUL) responsible for PCWP degradation and utilization are a prominent feature of Bacteroidetes. In recent years, there have been tremendous efforts in elucidating how PULs assist Bacteroidetes to assimilate carbon and acquire energy from PCWP. Here, we will review the PUL-mediated plant cell wall polysaccharides utilization in the gut Bacteroidetes focusing on cellulose, xylan, mannan, and pectin utilization and discuss how the mechanisms can be exploited to modulate the gut microbiota.     

2种侧围加强内框总成检具结构对比分析

概述了侧围加强内框总成与周边零件的匹配关系,从检具操作的人机工程出发,描述了侧围加强内框总成检具的2种定位方式和结构设计,对比了2种定位方式对于检测结果的影响,总结了其优点和弊端,结果表明侧围加强内框总成检具采用车内方向朝下的定位方式效果更好。     

凌庄子水厂保水堰流量系数试验

凌庄子水厂蓄水池进水口处有一保水堰,为非标准薄壁堰,不能使用已有堰流公式对其过流量进行准确计算。为了得出较为精确的过流流量,按照重力相似准则制作几何比尺为1∶5的模型进行试验研究。在已有自由出流公式的基础上,对自由出流流量系数进行修正并对淹没情况下流量变化过程进行研究。对该非标准堰自由出流流量系数的实测值与经验值进行分析比较,发现堰板槽降低了实际自由出流过流能力。淹没出流的流量系数主要与下游尾水位有关,试验中形成的淹没式堰流受实际堰型尺寸影响,下游尾水位和堰上水位近似相等,不完全适用已有淹没出流流量公式,通过试验给出了修正淹没系数随h/p的变化关系。结果表明利用堰前、堰后水位初步计算过流流量是可行的,可为该工程提供参考,也可为实际工程中非标准矩形堰的流量计算提供思路。     

Experimental investigation of the effects of contraction on tsunami-induced forces and pressures on a box section bridge

Many bridges that lie within possible tsunami inundation zones are critical links in transport networks. Some efforts have been made to determine the effects of tsunamis on bridges, but only a limited range of published design guidelines are available. Therefore, it is necessary to further investigate the effects of tsunamis on bridges. In the current study, physical modeling experiments were carried out to measure bore impact forces and pressures for various tsunami bore strengths on a bridge deck with different abutment types (wing wall and spill-through) and different opening and submergence ratios. The experiments were conducted in a wave flume with dimensions of 14 × 1.2 × 0.8 m (length × width × height), equipped with an automatic gate designed to generate a tsunami bore. The horizontal and vertical forces showed an increasing trend with increasing submergence ratio for both types of abutment. However, the horizontal force showed a decreasing trend as the opening ratio decreased, while the vertical force initially increased as the opening ratio decreased, until it reached a peak value, and then it started to decrease. The overall shapes of the results for both types of abutment are similar, with higher values for spill-through abutments due to their lower energy dissipation rates. Based on the experimental data, empirical equations are proposed for estimation of tsunami loads as a function of opening and submergence ratios.     

煤基高能量密度燃料的合成及表征

高能量密度燃料是为新型高性能飞行器提供动力保障的关键,其合成及应用研究具有重要的前瞻性和重大战略意义。煤炭是我国的主体能源和重要原料,通过煤直接转化获取的煤基油,充分保留了煤中特有的环状分子化学结构,具有良好的热安定性和较高的能量密度,被认为是高超音速飞行器的优选燃料。以煤直接液化工艺生产的煤液化石脑油馏分为起始原料,通过富集轻质芳烃、化学合成、催化加氢稳定和产物分离提纯等方法制备煤基高能量密度燃料,并对其产物进行分子结构表征和性能评价。结果表明,煤直接液化生产的石脑油馏分是一种优异的催化重整原料,经催化重整富集轻质芳烃后,其轻质芳烃质量分数高达71.05%。Diels-Alder化学合成主产物是由多个封闭环平面组成且具有空间立体构型的二环或三环烃类物质,质量分数为46.18%,因分子内存在较大的张力能,结构紧凑,其拥有更大的密度和体积热值。煤基高能量密度燃料的密度和体积热值分别为0.8990 g/cm3与38.06 MJ/L,均大大超过现行的国内石油基喷气燃料(RP-3和RP-6)、煤基大比重喷气燃料、美国和俄罗斯军用标准。与单一纯物质合成高能量密度燃料(JP-10和T-10)比较,其密度与体积热值偏小。究其原因主要是轻质芳烃的富集度仅为71.05%,需进一步提高其轻质芳烃质量分数。另外,制备的煤基高能量密度燃料种类复杂,其主产物质量分数仅46.18%,下一步可重点调控合成产物的分子构型和纯化分离。     

Large domain-wall currents in epitaxial Au/BiFeO3/SrRuO3 thin-film capacitors with modulated oxygen vacancy and wall densities

Large domain wall (DW) conductivity in an insulating ferroelectric plays an important role in the future nanosensors and nonvolatile memories. However, the wall current was usually too small to drive high-speed memory circuits and other agile nanodevices requiring high output-powers. Here, a large domain-wall current of 67.8 μA in a high on/off ratio of ~4460 was observed in an epitaxial Au/BiFeO₃/SrRuO₃ thin-film capacitor with the minimized oxygen vacancy concentration. The studies from read current-write voltage hysteresis loops and piezo-response force microscope images consistently showed remaining of partially unswitched domains after application of an opposite poling voltage that increased domain wall density and wall current greatly. A theoretical model was proposed to explain the large wall current. According to this model, the domain reversal occurs with the appearance of head-to-head and tail-to-tail 180° domain walls (DWs), resulting in the formation of highly conductive wall paths. As the applied voltage increased, the domain-wall number increased to enhance the on-state current, in agreement with the measurements of current-voltage curves. This work paves a way to modulate DW currents within epitaxial Au/BiFeO₃/SrRuO₃ thin-film capacitors through the optimization of both oxygen vacancy and domain wall densities to achieve large output powers of modern domain-wall nanodevices.     

Influence of bio-clogging on permeability characteristics of soil

It is necessary to enhance the barrier performance of cutoff walls in order to improve the contamination control level, especially for reconstruction or expansion of existing landfill sites. This paper presents a comprehensive laboratory investigation on the synergistic effects of microorganisms and fibers on the hydraulic conductivity of silty sand to evaluate the applicability to the field condition as an alterative barrier material. Inside the soil, the added carbon fibers not only provided good biocompatibility, but also formed spatial three-dimensional network between soil particles to improve the bacterial adhesion that eventually caused 2–3 orders of magnitude decrease in soil permeability. The resistance of the biofilm to extreme conditions was tested by permeation with solutions of different salinity and pH values, and by subjecting specimens to various hydraulic gradients and soil conditions. Despite the microbial growth inhibition occurred at these conditions, however, biofilm can largely remain intact and continue to reduce k, which due to the gradual adaptation of microorganisms to the extreme environment and the gradual recovery of their activity. Results of these tests demonstrate that biofilm treatment may be a feasible technology for creating waste containment barriers in soil.     

Quaternäre Metall/Metalloxid‐Katalysatoren als Wandkatalysatoren in Mikroreaktoren für Power‐to‐Gas‐Applikationen mittels kombinatorischer Hochdurchsatzmethoden

Catalysts of quaternary composition have been prepared and tested for the Sabatier process. For catalyst syntheses the following techniques have been used: sol‐gel methods, wet impregnation and incipient wetness impregnation. The Sabatier reaction was carried out at temperatures between 520 K and 670 K, pressures of 15 bar and 30 bar using a mixture H₂:CO₂ of 4:1. Activity screening of the microscale wall catalysts was performed by a custom‐built 10‐fold parallel gas‐flow microreactor setup in sequential operating mode. To analyze the gas phase compositions GC‐FID was used.